지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술대회자료
- 저자정보
- 발행연도
- 1999.6
- 수록면
- 239 - 244 (6page)
이용수
초록· 키워드
오류제보하기
Aluminum sulfate (alum) as a representative retention aid in papermaking processes was added to pulp suspensions, and the aluminum components adsorbed on the pulp were investigated quantitatively by two types of X-ray elementary analyses with regard to simultaneous changes of their surface charges. Xray photoelectron spectroscopy (XPS) and X-ray fluorescence analysis (XFA) were applied to determine the aluminum components retained in pulp pads up to ca. 10 nm and 100 11m depth, respectively. In other words, XPS was utilized to analyze the outermost surface layers of the samples, and XFA was available for measurement of their extensive regions. A particle charge detector (PCD) was used to monitor streaming potentials at various pHs of the pulp mixtures under moderate sharing conditions. At pH 4.5 of pulp suspensions containing alum, surface charges of pulp fibers varied from negative to slight negative (approximately neutral) according to adsorption of aluminum components onto the pulp fibers. Subsequently, when a dilute NaOH solution in limited amounts was added to pulp mixtures. both streaming potentials and surface aluminum content of the pulp fibers increased distinctly although little total aluminum retention increased. Further addition of alkali solutions brought drastic decreases of the surface charges and surface aluminum content, while total aluminum content, on the contrary. increased gradually under neutral conditions.
These results indicate that residual aluminum ions remained in pulp suspensions are predominantly adsorbed on surfaces of pulp fibers by adequate alkali additions, and they must sufficiently cationize the fiber surfaces with increases of somewhat cationic aluminum complexes formed on the surfaces. On the other hand, aluminum components formed in higher pH ranges have nearly no contribution to improvement of charge properties of the pulp fiber surfaces, even though aluminum retention in pulp pads increases. XPS and XFA analyses combined with streaming potential measurement using a PCD suggest close relationships between aluminum content on the pulp fiber surfaces and their charge properties.
These results indicate that residual aluminum ions remained in pulp suspensions are predominantly adsorbed on surfaces of pulp fibers by adequate alkali additions, and they must sufficiently cationize the fiber surfaces with increases of somewhat cationic aluminum complexes formed on the surfaces. On the other hand, aluminum components formed in higher pH ranges have nearly no contribution to improvement of charge properties of the pulp fiber surfaces, even though aluminum retention in pulp pads increases. XPS and XFA analyses combined with streaming potential measurement using a PCD suggest close relationships between aluminum content on the pulp fiber surfaces and their charge properties.
목차
ABSTRACT
INTRODUCTION
EXPERIMENTAL
RESULTS AND DISCUSSION
CONCLUSIONS
REFERENCES
참고문헌 (0)
참고문헌 신청함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
[Oral Session 2] ADSORPTION BEHAVIOR OF ALUMINUM COMPOUNDS ON PULP FIBERS AT WET-END
한국펄프종이학회 기타 간행물
1999 .06
-
각종 단섬유펄프를 이용한 화선지 제조
펄프·종이기술
2005 .06
-
주요 농업부산물로 제조한 크라프트 펄프의 물리적 특성 평가
펄프·종이기술
2014 .06
-
Effect of Modified Pulp on Tissue Properties
한국펄프·종이공학회 학술발표논문집
2018 .04
-
칡뿌리 섬유의 특성 및 섬유 자원화에 관한 연구(제2보) : 칡뿌리 섬유의 펄프화 및 쉬트 표면 특성
펄프·종이기술
2011 .06
-
펄프 종류와 지료 내 미세분 함량이 고분자전해질 multilayering에 미치는 영향
펄프·종이기술
2008 .09
-
기능성 섬유원료 개발을 위한 연잎줄기 펄프의 특성
펄프·종이기술
2010 .06
-
[Originals]Mechanical Impact Treatment on Pulp Fibers and Their Handsheet Properties
펄프·종이기술
2002 .12
-
Organic Acid Based Pulping of Wheat Straw for Production of Paper Grade Pulp
한국펄프종이학회 기타 간행물
2006 .06
-
활엽수 표백 크라프트 펄프 대체용 바가스 펄프의 배합비에 따른 수초지의 강도 특성 변화
펄프·종이기술
2017 .02
-
개미산–과산화수소 펄핑에 의하여 생산된 백합나무 펄프의 화학적 및 역학적 특성 분석
펄프·종이기술
2013 .02
-
크라프트펄프화법을 이용한 왕겨 섬유의 펄핑 적성 평가
펄프·종이기술
2020 .06
-
왕겨섬유 활용을 위한 왕겨 펄프화 연구
펄프·종이기술
2012 .06
-
베트남산 대나무의 펄프화 특성
펄프·종이기술
2009 .12
-
침 · 활엽수 LAS Pulp의 수초특성
한국펄프·종이공학회 학술발표논문집
2019 .04
-
습식성형 조건에 의한 습식펄프몰드 특성변화
펄프·종이기술
2020 .08
-
MARKET PULP 현황과 전망
한국펄프종이학회 기타 간행물
2008 .11
-
Effect of Mechanical Impact Treatment on Fiber Morphology and Handsheet Properties
한국펄프·종이공학회 학술발표논문집
2001 .11
-
충전제의 Pulp 표면개질에 의한 보류도 개선
한국펄프·종이공학회 학술발표논문집
2007 .10
-
국산 리파이너 바를 이용한 리파이닝 효과 연구
펄프·종이기술
2017 .12
이 논문의 저자 정보
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2009-586-014215938