지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술대회자료
- 저자정보
- 발행연도
- 1999.6
- 수록면
- 286 - 290 (5page)
이용수
초록· 키워드
오류제보하기
The chemical composition of crops from banana (Musa accuminata Colla) was studied. Two types of material were investigated, namely: the whole material (type Ⅰ) and the outer bark material (type Ⅱ), which was apparently rich in cellulose fibres. These characterisation showed that the amount of holocellulose is high enough (~70%) to envisage the pulping of this material despite its surprisingly high content of ashes (~14%). It is worth noting that. as expected. the type Ⅱ material was found more rich in cellulose.
Soda and Soda-Anthraquinone cooking processes were carried out using mini-digestors and the optimal pulping conditions were established. In fact. it was found that the maximum of yield is obtained when the following pulping conditions are respected: alcali 18%. time of the reaction: 1 hour to reach the isothermal regime and 30 min of pulping at 120℃. The kappa number of theses pulps was found around 30, which is very acceptable for unbleached pulps. The use of anthraquinone was found to increase the yield of pulps very slightly. The morphology of the fibers thus obtained was determined and showed that about 80% of fibres have a length between 1.4 and 1.9㎛. The width of these fibres was also determined and found in the range of 10-30㎛. Finally, hand sheet paper with two basis weights (60 and 135 g/m²) were made from pulps using the optimal conditions of cooking (300 g OD of crops). The yield and the kappa number of this cooking were very close to those found in mini-digestor reactions. The unbeaten pulps had a relatively high Shopper degree (59°SR) and the drainage was slow when the paper sheets were made. These papers showed good physical mechanical properties. The high basis weight was submitted to test which are specific to corrugated boards and showed very interesting values of RCT, CMf and FCT.
Soda and Soda-Anthraquinone cooking processes were carried out using mini-digestors and the optimal pulping conditions were established. In fact. it was found that the maximum of yield is obtained when the following pulping conditions are respected: alcali 18%. time of the reaction: 1 hour to reach the isothermal regime and 30 min of pulping at 120℃. The kappa number of theses pulps was found around 30, which is very acceptable for unbleached pulps. The use of anthraquinone was found to increase the yield of pulps very slightly. The morphology of the fibers thus obtained was determined and showed that about 80% of fibres have a length between 1.4 and 1.9㎛. The width of these fibres was also determined and found in the range of 10-30㎛. Finally, hand sheet paper with two basis weights (60 and 135 g/m²) were made from pulps using the optimal conditions of cooking (300 g OD of crops). The yield and the kappa number of this cooking were very close to those found in mini-digestor reactions. The unbeaten pulps had a relatively high Shopper degree (59°SR) and the drainage was slow when the paper sheets were made. These papers showed good physical mechanical properties. The high basis weight was submitted to test which are specific to corrugated boards and showed very interesting values of RCT, CMf and FCT.
목차
ABSTRACT
INTRODUCTION
EXPERIMENTAL
RESULTS AND DISCUSSION
CONCLUSIONS
ACKNOWLEDGEMENTS
REFERENCES
참고문헌 (0)
참고문헌 신청함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
New Zealand Radiata Pine Market Kraft Fibre and Pulp Papermaking Qualities
펄프·종이기술 국제 세미나
1990 .12
-
Improvement of Hardwood Pulp Yield in Continuous Kraft Cooking and Estimation of Pulp Yields Pulp yields of isothermal cooking with polysulfide and anthraquinone
한국펄프종이학회 기타 간행물
2006 .06
-
[Poster Presentation] IS THE EXTRACTIVES PLAY ANY POLE IN COLORING PULPS FROM Pinus pinaster?
한국펄프종이학회 기타 간행물
1999 .06
-
The Social/Public Responsibility of Papermaking Company
펄프·종이기술 국제 세미나
2005 .06
-
Efficient Use of Wood Fibers in Papermaking
펄프·종이기술 국제 세미나
2005 .06
-
뉴질랜드산 라디에타 펄프 특성 ( New Zealand Radiata Pine Market Kraft Fibre and Pulp Papermaking Qualities )
펄프·종이기술
1991 .06
-
Preliminary Study on Organosolv Pulping of Acacia Hybrid
Journal of forest and environmental science
2013 .01
-
[Poster Presentation] The Properties of Activated Carbon from Waste Newspaper
한국펄프종이학회 기타 간행물
1999 .06
-
Organic Acid Based Pulping of Wheat Straw for Production of Paper Grade Pulp
한국펄프종이학회 기타 간행물
2006 .06
-
Acacia - The Fibre of Choice
한국펄프종이학회 기타 간행물
2006 .06
-
Automation - Your Tools to Papermaking Profitability
펄프·종이기술
1997 .06
-
Prototyping Sustainable Banana Based Cropping Systems with the SIMBA Model
한국원예학회 기타 간행물
2006 .08
-
Antibacterial effects on oral microorganism of the mixtures based on Schizandra fruits and banana pulps
한국식품영양과학회 학술대회발표집
2018 .10
-
Automation - Your Tools to Increase Papermaking Profitability
펄프·종이기술 국제 세미나
1996 .01
-
제지공정의 개선 및 품질관리에 관한 연구 - 고해조건 및 펄프종류가 종이의 물리적 기계적 성질 및 그 상관에 미치는 영향 - ( Studies on the Improvement of Papermaking Process and Quality Control - Effect of Beating Conditions and Pulp Type on the Physical and Mechanical Properties of Paper and its Correlation - )
펄프·종이기술
1987 .06
-
The Middle Lamella Remainders on the Surface of Various Mechanical Pulp Fibres
한국펄프종이학회 기타 간행물
2006 .06
-
한국 제지산업의 현황
펄프·종이기술 국제 세미나
2007 .05
-
Evaluation of Low Consistency Refining Systems of Paper Mills in Achieving Optimal Fibre Development of Chemical Pulps
한국펄프·종이공학회 학술발표논문집
2016 .10
-
[Poster Presentation] A SPECTROSCOPIC STUDY OF THE OPTICAL PROPERTIES OF VARIOUS PAPERS MADE FROM RECLAIMED FIBRES
한국펄프종이학회 기타 간행물
1999 .06
-
Bioethanol Production Using Lignocellulosic Biomass review Part I. Pretreatments of biomass for generating ethanol
펄프·종이기술
2010 .12
이 논문의 저자 정보
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2009-586-014216011