지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
이 논문의 연구 히스토리 (2)
- 이 논문의 후속연구가 궁금하신가요?
- 연관 학술논문 또는 학술발표를 통해 보다 발전된 연구결과를 확인하실 수 있습니다.
- 이 논문의 연구 히스토리 확인하기
초록· 키워드
오류제보하기
This paper analyzes EM(Electromagnetic) characteristic in the high voltage connector for the hybrid electric vehicle. The connector bridges the electrical components and helps transferring electrical power and signal through it. The necessity of the high voltage and current connector development is emphasized because the hybrid electric vehicle recently uses the high voltage and current more than 500V and 80A. So far there has not been international EMC (Electromagnetic Compatibility) standards to limit the RE(Radiation Emission) from the connector for the hybrid electric vehicle. In this paper we analyzed EM characteristic of the 288V, 65A connector to check if the RE from the high voltage connector could be within the RE limit standard of vehicle. Three-dimensional modeling and simulation was conducted by using MWS(Microwave Studio) of the CST corporation, and the result was compared with the measured RE data, which showed good coincidence each other.
목차
Abstract
1. 서론
2. 본론
3. 결론
감사의 글
참고문헌
저자소개
참고문헌 (9)
참고문헌 신청
C.C. Chan / 2007 / The State of the Art of Electric, Hybrid, and Fuel Cell Vehicles / Proceedings of the IEEE
Yakup Bayram / 2006 / High Power EMI on Digital Circuits within Automotive Structures / IEEE International Symposium on Electromagnetic Compatibility
P. Andersen / 2009 / The present status of the international automotive EMC standards / IEEE International Symposium on Electromagnetic Compatibility
Youn Hee Lee / Analysis and modeling of conductive EMI noise of power electronics converters in electric and hybrid electric vehicles / Twenty-Third Annual IEEE on Applied Power Electronics Conference and Exposition
Jody J. Nelson / 2007 / High Voltage Automotive EMC Component Measurements Using an Artificial Network / 18th International Zurich Symposium on Electromagnetic Compatibility
Yakup Bayram / 2006 / High Power EMI on Digital Circuits within Automotive Structures / IEEE International Symposium on Electromagnetic Compatibility
P. Andersen / 2009 / The present status of the international automotive EMC standards / IEEE International Symposium on Electromagnetic Compatibility
Youn Hee Lee / Analysis and modeling of conductive EMI noise of power electronics converters in electric and hybrid electric vehicles / Twenty-Third Annual IEEE on Applied Power Electronics Conference and Exposition
Jody J. Nelson / 2007 / High Voltage Automotive EMC Component Measurements Using an Artificial Network / 18th International Zurich Symposium on Electromagnetic Compatibility
이 논문의 저자 정보
이 논문과 함께 이용한 논문
하이브리드 자동차용 고전압/대전류 커넥터 모듈 개발
강남진
,
김형락
,
최경석
외 3명
금형가공 심포지엄
2009
.11
하이브리드 자동차용 고전압 커넥터의 EM 특성 분석
이준상
,
남기훈
,
배현주
외 2명
대한전기학회 학술대회 논문집
2010
.07
하이브리드 자동차용 고전압 커넥터 개발
노용준
,
연복희
한국자동차공학회 춘 추계 학술대회 논문집
2008
.11
하이브리드 자동차용 고전압 커넥터의 전자파 차폐 및 최적 설계에 관한 연구
김성웅
,
최정욱
,
김형락
외 4명
대한기계학회 춘추학술대회
2010
.11
Study on power line communication for high voltage cables of electric vehicles
Jaehwan Jeong
,
Kyung
,
ak Sohn
Journal of Advanced Marine Engineering and Technology (JAMET)
2020
.02
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2012-560-003795539