지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술대회자료
- 저자정보
- 발행연도
- 2012.5
- 수록면
- 398 - 406 (9page)
이용수
이 논문의 연구 히스토리 (2)
- 이 논문의 후속연구가 궁금하신가요?
- 연관 학술논문 또는 학술발표를 통해 보다 발전된 연구결과를 확인하실 수 있습니다.
- 이 논문의 연구 히스토리 확인하기
초록· 키워드
오류제보하기
The aim of this study is to compare old standard EN 954-1 and new standard EN ISO 13849-1 through case study and provide necessity of adaptation of EN ISO 13849-1 in Korea. International and EU harmonized standard EN ISO 13849 “safety of machinery - Safety-related parts of control system” is classified into Part 1: General principles for design and Part 2: Validation. EN ISO 13849-1 standard was introduced in Official Journal of the European Union on September 8, 2009 as harmonized standard, and old standard EN 954-1 was withdrawn on December 31, 2011. So, EU decided to use of EN ISO 13849-1 standard forcibly from January 1, 2012 for safety of machinery. New machines need to be CE marked if they are to be placed on the market in the European Economic Area (EEA), Switzerland or Turkey, and Korean machine builder should apply EN ISO 3849-1 standard for safety of machinery accordingly. However, current Korean Safety Certification system (KCs mark) for dangerous machinery is not referred to EN ISO 13849-1 standard as safety standard. There is a need of research for adaptation of EN ISO 13849-1 standard in Korea as safety standards for new design of safety-related control system which use mostly electronic components. Two case studies of representative designs for safety-related control system in accordance with EN 954-1were selected according to safety category from B to 4. And these two representative designs were tried to change new design in accordance with EN ISO 13849-1 standard. The results of comparison were analyzed in aspect of economy and technical complexity. The results showed that EN ISO 13849-1 provided quantitative method of application and it enable designers to create safety-related control systems that require fewer components and less wiring, with many of the components being to a lower specification and, therefore, less costly. And EN ISO 13849-1 standard is good for electronic safety-related control systems compare to EN 954-1. By considering the importance of application of EN ISO 13849-1 and benefits, the application of EN ISO 13849-1 as safety standard for safety of machinery is urgent in Korea. The results of comparing EN 954-1 and EN ISO 13849-1 standard might help to determine the adaptation of EN ISO 13849-1 standard for safety of machinery in Korea.
목차
ABSTRACT
1. Introduction
2. Objective and Method
3. Major Key points of EN ISO 13849-1
4. Case studies of comparing EN 954-1 and EN ISO 13849-1
5. Conclusion
References
참고문헌 (0)
참고문헌 신청이 논문의 저자 정보
이 논문과 함께 이용한 논문
최근 본 자료
댓글(0)
0