메뉴 건너뛰기
.. 내서재 .. 알림
소속 기관/학교 인증
인증하면 논문, 학술자료 등을  무료로 열람할 수 있어요.
한국대학교, 누리자동차, 시립도서관 등 나의 기관을 확인해보세요
(국내 대학 90% 이상 구독 중)
로그인 회원가입 고객센터 ENG
주제분류

추천
검색
질문

논문 기본 정보

자료유형
학술대회자료
저자정보
Pham Thanh Nhut (울산대학교) Tae Hyoung Kim (울산대학교) Young Jin Yum (울산대학교)
저널정보
대한기계학회 대한기계학회 춘추학술대회 대한기계학회 2012년도 추계학술대회 논문집
발행연도
2012.11
수록면
392 - 395 (4page)

이용수

표지
📌
연구주제
📖
연구배경
🔬
연구방법
🏆
연구결과
AI에게 요청하기
추천
검색
질문

이 논문의 연구 히스토리 (2)

초록· 키워드

오류제보하기
The lap-joint composite samples were fabricated by hand lay-up and vacuum method at room temperature whose main components are unsaturated polyester, fiberglass woven and mat. The adhesive used in joints is also unsaturated polyester resin. Joining process of the specimens was performed on six types of surface with two different methods: terminal-joint and secondary-joint but the same geometry properties. Experiment method was used to determine the mechanical properties of adhesive, adherends, terminal-joint and secondary-joint specimens. The tensile test results and geometry parameters of specimens were combined with bonding theory to calculate the maximum and average shear stresses. Six joints were compared and evaluated together by the results of maximum and average shear stresses. From the results, it was observed that grind/acetone case had the highest strength in three types of terminal-joint and grinding case had near the same value. For secondary-joints, mat-mat and mat-woven case had the highest strength with the same value. While no treatment and woven-woven bonding had very low strength. For failure tendency, it occurred strongly at two ends and then moved to the middle area of overlap length in x-z plane but only appeared at an edge and then spread to opposite edge in x-y plane.

목차

Abstract
1. INTRODUCTION
2. THEORY AND EXPERIMENTAL
3. RESULTS AND DISCUSSIONS
4. CONCLUSIONS
REFERENCES

참고문헌 (0)

참고문헌 신청

이 논문의 저자 정보

이 논문과 함께 이용한 논문

최근 본 자료

전체보기

댓글(0)

0

UCI(KEPA) : I410-ECN-0101-2014-550-000187688