지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술대회자료
- 저자정보
- 저널정보
- 한국소성·가공학회 기타자료 The 8th International Conference and Workshop on numerical simulation of 3D seet metal forming processes (NUMISHEET 2011)
- 발행연도
- 2011.8
- 수록면
- 800 - 806 (7page)
이용수
초록· 키워드
오류제보하기
Biaxial tensile tests of 6000 series aluminum alloy sheet with different density cube textures were carried out using cruciform specimens similar to that developed by one of the authors [Kuwabara, T. et al., J. Material Process. Technol., 80/81(1998), 517-523.]. The specimens are loaded under linear stress paths in a servo-controlled biaxial tensile testing machine. Plastic orthotropy remained coaxial with the principal stresses throughout every experiment. Successive contours of plastic work in stress space and the directions of plastic strain rates were precisely measured and compared with those calculated using selected yield functions. The Yld2000-2d yield functions with exponents of 12 and 6 [Barlat, F. et al., Int. J. Plasticity 19 (2003), 1297-1319] are capable of reproducing the general trends of the work contours and the directions of plastic strain rates observed for test materials with high and low cube textures, respectively. Hydraulic bulge tests were also conducted and the variation of thickness strain along the meridian direction of the bulged specimen was compared with that calculated using finite element analysis (FEA) based on the Yld2000-2d yield functions with exponents of 12 and 6. The differences of cube texture cause significant differences in the strain distributions of the bulged specimens, and the FEA results calculated using the Yld2000-2d yield functions show good agreement with the measurement results.
목차
Abstract
INTRODUCTION
EXPERIMENTAL METHOD
FINITE ELEMENT SIMULATION OF HYDRAULIC BULGE TEST
RESULTS AND DISCUSSION
CONCLUSIONS
REFERENCES
참고문헌 (0)
참고문헌 신청이 논문의 저자 정보
최근 본 자료
댓글(0)
0