메뉴 건너뛰기
.. 내서재 .. 알림
소속 기관/학교 인증
인증하면 논문, 학술자료 등을  무료로 열람할 수 있어요.
한국대학교, 누리자동차, 시립도서관 등 나의 기관을 확인해보세요
(국내 대학 90% 이상 구독 중)
로그인 회원가입 고객센터 ENG
주제분류

추천
검색
질문

논문 기본 정보

자료유형
학술대회자료
저자정보
M. Maarefdoust (Islamic Azad University) M. Kadkhodayan (Ferdowsi University) M. Goharimanesh (Iran University of Science and Technology)
저널정보
한국소성·가공학회 기타자료 The 8th International Conference and Workshop on numerical simulation of 3D seet metal forming processes (NUMISHEET 2011)
발행연도
2011.8
수록면
1,043 - 1,049 (7page)

이용수

표지
📌
연구주제
📖
연구배경
🔬
연구방법
🏆
연구결과
AI에게 요청하기
추천
검색
질문

초록· 키워드

오류제보하기
In this paper, using finite element analysis, an analytical comparison process of deep drawing steel sheet in two ways, ordinarily and reversely is considered. The results show that, under plane strain, steel sheet is caused suffering throat in the ordinary method, when achieves stretching deformation factor m = 0.162 (Ratio of final 13㎜ Initial width 80㎜), after suffering the effects of tensile deformation mechanism of activation failure. Whereas the same conditions of the process to reverse the stretching method, a whole sheet steel deformation without failure gives the amount of force needed to punch, per the same amounts of deformation of Reverse process of stretching is less than ordinary process .Changes in the stress of plate, displacement curve sheet, sheet strain changes for the two stretching modes and simple inverse elasticity are compared.

목차

Abstract
INTRODUCTION
MATERIALS AND METHOD
DEFINED BOUNDARY CONDITIONS AND PROCEDURE
RESULTS AND DISCUSSION
CONCLUDING REMARKS
REFERENCES

참고문헌 (0)

참고문헌 신청

이 논문의 저자 정보

최근 본 자료

전체보기

댓글(0)

0