메뉴 건너뛰기
.. 내서재 .. 알림
소속 기관/학교 인증
인증하면 논문, 학술자료 등을  무료로 열람할 수 있어요.
한국대학교, 누리자동차, 시립도서관 등 나의 기관을 확인해보세요
(국내 대학 90% 이상 구독 중)
로그인 회원가입 고객센터 ENG
주제분류

추천
검색
질문

논문 기본 정보

자료유형
학술저널
저자정보
Young-Sik Kim (Incheon campus Korea Polytechnics) Hyo-Min Jeong (Gyeongsang National University) Han-Shik Chung (Gyeongsang National University) Md.Riyad Tanshen (Gyeongsang National University) Dae-Chul Lee (Gyeongsang National University) Myoung-Kuk Ji (Forging) Kang-Youl Bae (Dae Myung GENT)
저널정보
한국동력기계공학회 동력시스템공학회지 한국동력기계공학회지 제17권 제2호
발행연도
2013.4
수록면
70 - 77 (8page)

이용수

표지
📌
연구주제
📖
연구배경
🔬
연구방법
🏆
연구결과
AI에게 요청하기
추천
검색
질문

초록· 키워드

오류제보하기
An experimental study was carried out to understand the heat transfer performance of a miniature loop heat pipes using water-based copper nanoparticles suspensions as the working fluid. The suspensions consisted of deionized water and copper nanoparticles with an average diameter of 80 ㎚. Effects of the cupper mass concentration and the operation pressure on the average evaporation and condensation heat transfer coefficients, the critical heat flux and the total heat resistance of the mLHPs were investigated and discussed. The pressure frequency also depends upon the evaporator temperature which has been maintained from 60℃ to 90℃. The Investigation shows 60% filling ratio gives the highest inside pressure magnitude of highest number pressure frequency at any of setting of evaporator temperature and 5wt% results the lowest heat flow resistance.

목차

Abstract
1. Introduction
2. Experimental setup
3. Data Reduction
4. Results and discussion
5. Conclusions
References

참고문헌 (10)

참고문헌 신청

이 논문의 저자 정보

이 논문과 함께 이용한 논문

최근 본 자료

전체보기

댓글(0)

0

UCI(KEPA) : I410-ECN-0101-2014-500-003596210