메뉴 건너뛰기
.. 내서재 .. 알림
소속 기관/학교 인증
인증하면 논문, 학술자료 등을  무료로 열람할 수 있어요.
한국대학교, 누리자동차, 시립도서관 등 나의 기관을 확인해보세요
(국내 대학 90% 이상 구독 중)
로그인 회원가입 고객센터 ENG
주제분류

추천
검색
질문

논문 기본 정보

자료유형
학술저널
저자정보
김철구 (서울대학교) 엄태성 (단국대학교) 박홍근 (서울대학교) 김태완 (강원대학교)
저널정보
대한건축학회 대한건축학회 논문집 - 구조계 大韓建築學會論文集 構造系 第31卷 第12號
발행연도
2015.12
수록면
23 - 33 (11page)

이용수

표지
📌
연구주제
📖
연구배경
🔬
연구방법
🏆
연구결과
AI에게 요청하기
추천
검색
질문

초록· 키워드

오류제보하기
For small buildings designed to primarily resist gravity load, lap splices of longitudinal reinforcement are used in columns at the regions (e.g. at the bottom of the 1st floor) where flexural yielding is anticipated. Although not allowed under cyclic loading repeated in large inelastic range, such splices can be used as an alternative for the convenience of construction in small buildings where a limited ductility is required. In this study, cyclic loading test was performed for columns using lap splices at the plastic hinge regions. The length and offset bar details of lap splices and the ratio of shear span and section height (or aspect ratio) were considered as the test parameters. Non-seismic hoops of 90-degree end hooks were provided over the lap length. Test results showed that the strength and ductility of columns were significantly varied depending on the offset bar details and length of lap splices. In addition, the aspect ratio also had significant impact on the performance of lap splices due to change of the bond demand in the splice zone. The columns lap spliced in the plastic hinge zone were vulnerable to vertical cracking (or concrete splitting) along the lap length. Based on the test results and the review of existing studies, design recommendations for calculating lap spliced length of columns at plastic hinge zone were proposed.

목차

Abstract
1. 서론
2. 문헌 고찰
3. 실험계획
4. 실험 결과
5. 설계변수에 따른 겹침이음 성능
6. 결론
REFERENCES

참고문헌 (18)

참고문헌 신청

함께 읽어보면 좋을 논문

논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!

이 논문의 저자 정보

이 논문과 함께 이용한 논문

최근 본 자료

전체보기

댓글(0)

0

UCI(KEPA) : I410-ECN-0101-2016-540-002338316