지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 발행연도
- 2011.1
- 수록면
- 113 - 118 (6page)
이용수
이 논문의 연구 히스토리 (2)
- 이 논문의 후속연구가 궁금하신가요?
- 연관 학술논문 또는 학술발표를 통해 보다 발전된 연구결과를 확인하실 수 있습니다.
- 이 논문의 연구 히스토리 확인하기
초록· 키워드
오류제보하기
It is not easy to predict the shrinkage rate of a plastic injection mold in its design process. The shrinkage rate should be considered as one of the important performances to produce the reliable products.
The shrinkage rate can be determined by using the CAE tools in the design produces. However, since the analysis can take minutes to hours, the high computational costs of performing the analysis limit their use in design optimization. Therefore this study was carried out to presume for mutual relation of analysis condition to get the optimum average shrinkage by regression analysis. The results shown that coefficient of determination of regression equation has a fine reliability over 87% and regression equation of average shrinkage is made by regression analysis
목차
등록된 정보가 없습니다.
참고문헌 (7)
참고문헌 신청
C. Y. Zhang / 1997 / Adaptive Controller Performance Used for Ram Velocity Control during Filling Phase," Byeong- Hyeon Min, "An Analysis of Shrinkge of Injection Molded part
D. Yao / 1998 / Diract Search-Based Automatic Minimization of Warpage and Weldlines in Injection Molded Parts / 석사 / University of Massachusetts
M. R. Ryu / 2005 / Injection mold Design Optimization using Regression Analysis / KSPE, Autumn Conference
Suzanne L / 1996 / Online Pattern-Beased Part Quality monitoring of the Injection Molding Process / Polymer Eng. & Sci., Mid-jun 36 (11)
V. Leo / 1996 / The Effect of the Parking Parameters, Gate Geometry, And Mold Elasticity on the Final Dimensions of a Molded Part / Polymer Eng. & Sci., Mid-August 36 (15
D. Yao / 1998 / Diract Search-Based Automatic Minimization of Warpage and Weldlines in Injection Molded Parts / 석사 / University of Massachusetts
M. R. Ryu / 2005 / Injection mold Design Optimization using Regression Analysis / KSPE, Autumn Conference
Suzanne L / 1996 / Online Pattern-Beased Part Quality monitoring of the Injection Molding Process / Polymer Eng. & Sci., Mid-jun 36 (11)
V. Leo / 1996 / The Effect of the Parking Parameters, Gate Geometry, And Mold Elasticity on the Final Dimensions of a Molded Part / Polymer Eng. & Sci., Mid-August 36 (15
이 논문의 저자 정보
최근 본 자료
댓글(0)
0