지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 저널정보
- 국제구조공학회 Structural Engineering and Mechanics, An Int'l Journal Structural Engineering and Mechanics, An Int'l Journal Vol.90 No.6
- 발행연도
- 2024.6
- 수록면
- 611 - 633 (23page)
이용수
초록· 키워드
오류제보하기
This study intends to investigate the response of multi-cell (MC) beams to flexural loads in which the primary reinforcement is composed of both metallic and non-metallic materials. “Multi-cell” describes beam sections with multiple longitudinal voids separated by thin webs. Seven reinforced concrete MC beams measuring 300×200×1800 mm were tested under flexural loadings until failure. Two series of beams are formed, depending on the type of main reinforcement that is being used. A control RC beam with no openings and six MC beams are found in these two series. Series one and two are reinforced with metallic and non-metallic main reinforcement, respectively, in order to maintain a constant reinforcement ratio. The first crack, ultimate load, deflection, ductility index, energy absorption, strain characteristics, crack pattern, and failure mode were among the structural parameters of the beams under investigation that were documented. The primary variables that vary are the kind of reinforcing materials that are utilized, as well as the kind and quantity of mesh layers. The outcomes of this study that looked at the experimental and numerical performance of ferrocement reinforced concrete MC beams are presented in this article. Nonlinear finite element analysis (NLFEA) was performed with ANSYS-16.0 software to demonstrate the behavior of composite MC beams with holes. A parametric study is also carried out to investigate the factors, such as opening size, that can most strongly affect the mechanical behavior of the suggested model. The experimental and numerical results obtained demonstrate that the FE simulations generated an acceptable degree of experimental value estimation. It’s also important to demonstrate that, when compared to the control beam, the MC beam reinforced with geogrid mesh (MCGB) decreases its strength capacity by a maximum of 73.33%. In contrast, the minimum strength reduction value of 16.71% is observed in the MC beams reinforced with carbon reinforcing bars (MCCR). The findings of the experiments on MC beams with openings demonstrate that the presence of openings has a significant impact on the behavior of the beams, as there is a decrease in both the ultimate load and maximum deflection.
목차
등록된 정보가 없습니다.
참고문헌 (0)
참고문헌 신청함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
Impact of openings on the structural performance of ferrocement I-Beams under flexural loads
Structural Engineering and Mechanics, An Int＇l Journal
2024 .05
-
Experimental, Numerical, and Analytical Investigation of the Reinforced Concrete Hidden and Wide Beams
International Journal of Concrete Structures and Materials
2025 .01
-
Shear Behavior of Reactive Powder Concrete Ferrocement Beams with Light Weight Core Material
International Journal of Concrete Structures and Materials
2024 .09
-
Post-heating behavior of concrete beams reinforced with fiber reinforced polymer bars
Structural engineering and mechanics : An international journal
2015 .01
-
Numerical simulation of concrete beams reinforced with composite GFRP-Steel bars under three points bending
Structural engineering and mechanics : An international journal
2016 .01
-
Post-heating behavior of concrete beams reinforced with fiber reinforced polymer bars
Structural Engineering and Mechanics, An Int＇l Journal
2015 .01
-
A study on load-deflection behavior of two-span continuous concrete beams reinforced with GFRP and steel bars
Structural Engineering and Mechanics, An Int＇l Journal
2017 .01
-
A study on load-deflection behavior of two-span continuous concrete beams reinforced with GFRP and steel bars
Structural engineering and mechanics : An international journal
2017 .01
-
Structural Performance of Ferrocement Beams Incorporating Longitudinal Hole Filled with Lightweight Concrete
International Journal of Concrete Structures and Materials
2023 .07
-
Experimental and Numerical Assessment of Reinforced Concrete Beams with Disturbed Depth
International Journal of Concrete Structures and Materials
2019 .11
-
패각을 사용한 철근콘크리트 유공보의 공학적 특성에 관한 연구
KIEAE Journal
2015 .02
-
Analytical and numerical modeling of interfacial stresses in beams bonded with a thin plate
Advances in computational design
2017 .01
-
Behavior of FRP‑Strengthened RC Beams with Large Rectangular Web Openings in Flexure Zones : Experimental and Numerical Study
International Journal of Concrete Structures and Materials
2018 .07
-
Large deflection analysis of edge cracked simple supported beams
Structural engineering and mechanics : An international journal
2015 .01
-
Experimental and Numerical Investigation of Shear Behavior of RC Beams Strengthened by Ultra-High Performance Concrete
International Journal of Concrete Structures and Materials
2019 .01
-
Flexural behaviour of GFRP reinforced concrete beams under cyclic loading
Structural Engineering and Mechanics, An Int＇l Journal
2022 .11
-
Experimental analysis of shear deficient reinforced concrete beams strengthened by glass fiber strip composites and mechanical stitches
Steel and Composite Structures, An International Journal
2021 .01
-
Large deflection analysis of a fiber reinforced composite beam
Steel and Composite Structures, An International Journal
2018 .01
-
Bending Behavior of RC Beams with Regular Web Openings and Non‑corroding GFRP Reinforcement
International Journal of Concrete Structures and Materials
2025 .01
-
Flexural performance of FRP-reinforced concrete encased steel composite beams
Structural engineering and mechanics : An international journal
2016 .01
최근 본 자료
댓글(0)
0