최근, 정부는 온실가스의 실질 배출량을 제로로 만드는 ‘탄소 중립’ 달성과 안전하고 깨끗한 에너지정책 전환을 위해, 2040년까지 신재생에너지발전량 비중을 30∼35%로 확대하는 정책을 적극적으로 추진하고 있다. 이에 따라 태양광전원 등의 신재생에너지 전원도입이 발전사업자들에 의해 급격히 증가하고 있다. 그러나, 태양광전원이 연계된 배전선로에서 1상이 단선 등으로 결상사 고가 발생할 경우, 태양광전원 연계용변압기의 철심형태 및 결선 방법에따라 여러 가지 문제점이 발생할 가능성이 있다. 즉, 결상사고 발생 시 태양광전원 인버터의 단독운전 방지기능에 따라 결상을 감지하여 발전을 정지해야 하지만, 결상을 인지하지 못하고 계속 발전하는 사례가 보고되고 있으며, 태양광전원 연계용변압기의 역조류 현상으로 인해 결상된 상으로 전원을 공급하여 계통에 악영향을 주는 문제점이 발생하고 있다. 이러한역조류로 인해 연계용변압기는 과부하로 소손될 수 있으며, 보호계전기오동작과 전력량계의 계량 오차 문제가 발생할 수 있다. 또한, 배전선로작업자는 결상으로 인한 정전으로 오인 할 수 있어서 보수작업 시 감전사 고가 발생할 가능성이 있다. 상기의 문제점을 해결하기 위해, 결상사고 발생 시 신속하게 결상을 검출하여 보호장치를 동작시켜야 하며, 기존에 채용되고 있는 결상사고 보호방식(open phase relay, 47)은 측정된 전압이 정정치 이하가 되었을 때동작하는 방식을 채용하고 있다. 하지만, 태양광전원이 연계된 배전선로에서 결상사고 발생 시 연계용변압기의 불평형 자속 등으로 결상된 상에 전압을 유기 시킬 수 있으므로, 기존에 사용되고 있는 결상사고 보호방식은결상 검출이 어려워, 새로운 결상사고 검출 알고리즘이 요구되고 있다. 따라서, 본 논문에서는 전류비교방식의 개념을 이용하여, 태양광전원 연계용변압기 1, 2차측의 전류와 위상 비교하고, 전류 불평형률을 고려하여결상사고를 검출하는 새로운 개념의 결상사고 검출 알고리즘을 제안한다. 또한, 전력계통 상용해석 프로그램인 PSCAD/EMTDC를 이용하여, 배전선로, 부하, 연계용변압기, 태양광전원으로 구성된 배전계통과 결상사고 검출 보호장치의 모델링을 수행하고, 이를 바탕으로 결상사고 검출 보호 장치를 구현한다. 상기의 모델링과 결상사고 검출 알고리즘을 바탕으로태양광전원 연계용변압기의 결선방식과 철심 구조에 따라 보호장치의 특성을 분석하고, 결상사고 검출 보호장치를 이용한 특성시험을 통해 본 논문의 결상사고 검출 알고리즘이 결상사고 보호방식에 유용함을 제시한다.
Recently, the installation of renewable energy sources(RES) such as PV system is being rapidly increased according to the Korean government policy of low-carbon green growth. However, when large scale PV systems are installed and operated in distribution system, open phase faults may be occurred at points of common coupling. Specifically, if open phase faults are occurred, the PV system should be stopped by prevention function of islanding of inverter, but it is reported that there are undetected cases for open phase circuit. And also, a phenomenon of open phase circuit may supply reverse power flow in grid-connected transformer. In the case of open phase faults caused by disconnection of distribution feeders interconnected with PV system, lots of problems may be occurred depending on the core type and wiring method of the grid-connected transformers. Moreover, it is difficult to detect open phase faults because the open phase voltage of existing protection relay(open phase relay (47)) can be maintained, even though disconnection fault is occurred, depending on the wiring method and the iron core type of grid-connected transformer for PV system. Therefore, this paper proposes a novel algorithm to detect open phase fault by comparing currents and phases between primary and secondary sides of grid-connected transformer. And also, this paper presents a modeling of distribution system and protection devices for detecting open phase fault using PSCAD/EMTDC S/W, and implements a test device of protection devices for detecting open phase fault based on above-mentioned modeling. From the simulation and test results, it is confirmed that the proposed modeling and test device are practical tools for fault analysis of open phase circuit according to wiring connection and iron core structure in grid-connected transformer. And also, it is validated that the proposed algorithm is useful for detecting open phase fault according to the wiring method and iron core type of grid-connected transformer for PV system.