지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 저널정보
- 한국콘크리트학회 International Journal of Concrete Structures and Materials International Journal of Concrete Structures and Materials Vol.11 No.2
- 발행연도
- 2017.6
- 수록면
- 301 - 313 (13page)
이용수
초록· 키워드
오류제보하기
This paper presents the fibre-matrix interfacial properties of hooked end steel fibres embedded in ultra-high performance mortars with various water/binder (W/B) ratios. The principle objective was to improve bond behaviour in terms of bond strength by reducing the (W/B) ratio to a minimum. Results show that a decrease in W/B ratio has a significant effect on the bondslip behaviour of both types of 3D fibres, especially when the W/B ratio was reduced from 0.25 to 0.15. Furthermore, the optimization in maximizing pullout load and total pullout work is found to be more prominent for the 3D fibres with a larger diameter than for fibres with a smaller diameter. On the contrary, increasing the embedded length of the 3D fibres did not result in an improvement on the maximum pullout load, but increase in the total pullout work.
목차
Abstract
1. Introduction
2. Experimental Programme
3. Results and Discussion
4. Conclusions
References
참고문헌 (47)
참고문헌 신청
Abbas, S., Nehdi, M., & Saleem, M. (2016). Ultra-high performance concrete: Mechanical performance, durability, sustainability and implementation challenges. International Journal of Concrete Structures and Materials, 10(3), 271?295.
Abdallah, S., Fan, M., & Rees, D. W. A. (2016a). Analysis and modelling of mechanical anchorage of 4D/5D hooked end steel fibres. Materials and Design, 112, 539?552.
Abdallah, S., Fan, M., & Zhou, X. (2016b). Effect of hookedend steel fibres geometry on pull-out behaviour of ultrahigh performance concrete. World Academy of Science, Engineering and Technology, International Journal of Civil, Environmental, Structural, Construction and Architectural Engineering, 10(12), 1530?1535.
Abdallah, S., Fan, M., Zhou, X., & Geyt, S. (2016c). Anchorage effects of various steel fibre architectures for concrete reinforcement. International Journal of Concrete Structures and Materials, 10, 325?335.
Abu-Lebdeh, T., Hamoush, S., Heard, W., & Zornig, B. (2011). Effect of matrix strength on pullout behavior of steel fiber reinforced very-high strength concrete composites. Construction and Building Materials, 25(1), 39?46.
함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
Pullout Behaviour of Different Types of Steel Fibres Embedded in Magnesium Phosphate Cementitious Matrix
International Journal of Concrete Structures and Materials
2019 .05
-
Numerical modelling of the pull-out response of inclined hooked steel fibres
Advances in concrete construction
2015 .01
-
Fast classification of fibres for concrete based on multivariate statistics
Computers and Concrete, An International Journal
2017 .01
-
Comparison of macrosynthetic and steel FRC shear-critical beams with similar residual flexure tensile strengths
Structural Engineering and Mechanics, An Int＇l Journal
2020 .01
-
Crack Propagation Analysis of Synthetic vs. Steel vs. Hybrid Fibre-Reinforced Concrete Beams Using Digital Image Correlation Technique
International Journal of Concrete Structures and Materials
2020 .11
-
Compressive strength and failure behaviour of fibre reinforced concrete at elevated temperatures
Advances in concrete construction
2015 .01
-
Investigating the Hybrid Effect of Micro-steel Fibres and Polypropylene Fibre-Reinforced Magnesium Phosphate Cement Mortar
International Journal of Concrete Structures and Materials
2022 .09
-
Comparisons Between Pull-Out Behaviour of Various Hooked-End Fibres in Normal-High Strength Concretes
International Journal of Concrete Structures and Materials
2019 .05
-
Formula to identify the Influence of steel fibres on the mechanical properties of HPC
Computers and Concrete, An International Journal
2020 .01
-
Behaviour of Carbon and Basalt Fibres Reinforced Fly Ash Geopolymer at Elevated Temperatures
International Journal of Concrete Structures and Materials
2018 .05
-
Experimental and microstructural evaluation on mechanical properties of sisal fibre reinforced bio-composites
Steel and Composite Structures, An International Journal
2019 .01
-
Effect of fibre loading and treatment on porosity and water absorption correlated with tensile behaviour of oil palm empty fruit bunch fibre reinforced composites
Advances in materials research : AMR
2017 .01
-
Prediction of Hybrid fibre-added concrete strength using artificial neural networks
Computers and Concrete, An International Journal
2015 .04
-
Experimental evaluation on comparative mechanical properties of Jute – Flax fibre Reinforced composite structures
Structural Engineering and Mechanics, An Int＇l Journal
2020 .01
-
Experiments on Tensile and Shear Characteristics of Amorphous Micro Steel (AMS) Fibre-Reinforced Cementitious Composites
International Journal of Concrete Structures and Materials
2017 .12
-
Mechanical behaviour of steel fibre reinforced SCC after being exposed to fire
Advances in concrete construction
2018 .01
-
Behaviour of hybrid fibre reinforced concrete beams strengthened with GFRP laminates
Structural engineering and mechanics : An international journal
2018 .01
-
Flexural behaviour of fibre reinforced geopolymer concrete composite beams
Computers and Concrete, An International Journal
2015 .03
-
Bond strength characterization and estimation of steel fibre reinforced polymer - concrete composites
Steel and Composite Structures, An International Journal
2022 .09
-
Fibrin affects short-term in vitro human mesenchymal stromal cell responses to magneto-active fibre networks
Biomaterials and biomedical engineering
2015 .01
이 논문의 저자 정보
최근 본 자료
댓글(0)
0
UCI(KEPA) : I410-ECN-0101-2018-532-000881285