메뉴 건너뛰기
.. 내서재 .. 알림
소속 기관/학교 인증
인증하면 논문, 학술자료 등을  무료로 열람할 수 있어요.
한국대학교, 누리자동차, 시립도서관 등 나의 기관을 확인해보세요
(국내 대학 90% 이상 구독 중)
로그인 회원가입 고객센터 ENG
주제분류

추천
검색
질문

논문 기본 정보

자료유형
학술저널
저자정보
김준현 (Seoul National University of Science & Technology) 최진우 (Seoul National University of Science & Technology) 성재용 (Seoul National University of Science & Technology) 이광용 (Paru) 김명길 (SPACEK) 조영준 (Korea Aerospace Research Institute)
저널정보
한국생산제조학회 한국생산제조학회지 한국생산제조학회지 Vol.30 No.6
발행연도
2021.12
수록면
495 - 504 (10page)
DOI
10.7735/ksmte.2021.30.6.495

이용수

표지
📌
연구주제
📖
연구배경
🔬
연구방법
🏆
연구결과
AI에게 요청하기
추천
검색
질문

초록· 키워드

오류제보하기
Herein, we reviewed satellite applications for the film heater with a silver-paste heating element fabricated by screen printing. Moreover, identical results were obtained by comparing the prototype heater and Engineering Model class calculationcharacteristics. For Flying Model class application, it was possible to maintain the temperature above 200℃, which can be shielded by PI using a silver element of thickness 6.26 μm, width of 2 mm, bus-voltage of 28 V, and electrical resistance of 25.8 Ω. If the maximum temperature does not exceed 200 ℃, a suitable heater for the sink temperature is used, and the maximum allowable power density is lowered to less than half of the European Space Components Coordination regulation (0.54 W/㎠). The calculated results showed an error when with the measured temperature in the test mode attaching a heater to the CFRP plate due to the high thermal resistance of film and adhesive layers.

목차

ABSTRACT
1. 서론
2. 실버-페이스트 필름 히터의 구조
3. 히터 해석 모델링
4. 결과 및 고찰
5. 결론
References

참고문헌 (12)

참고문헌 신청

이 논문의 저자 정보

이 논문과 함께 이용한 논문

최근 본 자료

전체보기

댓글(0)

0