지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 발행연도
- 2016.1
- 수록면
- 856 - 862 (7page)
이용수
초록· 키워드
오류제보하기
In this research, production of ferrite - martensite dualphase Steels with different martensite morphology was considered during transient liquid phase bonding of a low carbon steel. The steel was bonded using an iron base interlayer with melting point of 1443 K and 40 μm thickness. Bonding process carried out at 1473 K, under pressure of 0.5MPa, at different holding time of 10, 20, 30 and 40 minutes. Microstructural studies of joint region showed that isothermal solidification completed at the bonding time of 40 minutes. Microstructure of joints made at the bonding time of 10, 20, and 30 minutes consists of two distinct region, athermal and isothermal solidified zones. Microstructure of these zones was studied and chemical composition of these zones was determined by EDS. Joints made with bonding time of 40 minutes were homogenized at 1008 K and then cooled into cold water to produce dual phase ferrite and martensite microstructure with different martensite morphology. According to shear test results, it was found that the shear strength of ferrite - fibrous martensite microstructure is greater than those with ferrite - continuous martensite and ferrite - blocky martensite microstructure.
목차
등록된 정보가 없습니다.
참고문헌 (23)
참고문헌 신청
함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
Effect of Transformation Temperature on the Ferrite–Bainite Microstructures, Mechanical Properties and the Deformation Behavior in a Hot-Rolled Dual Phase Steel
Metals and Materials International
2021 .01
-
Transient Liquid Phase Bonding of 17-4-PH Stainless Steel Using Conventional and Two-Step Heating Process
Metals and Materials International
2021 .12
-
제어 압연과 가속 냉각에 의해 저탄소강에서 형성되는 미세조직의 특징과 구분
한국재료학회지
2017 .01
-
Effect of Solidification Mode on Microstructure and Mechanical Properties of AISI420 Steel to SAF2507 Steel Dissimilar Joint Produced by Transient Liquid Phase
Metals and Materials International
2020 .01
-
Microstructure Evolution Mechanism and Corrosion Behavior of Transient Liquid Phase Bonded 304L Stainless Steel
Metals and Materials International
2021 .09
-
Influence of the Deformation on the Microstructure and Mechanical Properties of TBF Steel
Journal of the Korean Society for Precision Engineering
2020 .08
-
전력반도체 패키징을 위한 Transient liquid phase 접합 기술
마이크로전자 및 패키징학회지
2017 .01
-
전기자동차용 Transient Liquid Phase Bonding 기술의 최신 연구 동향
대한용접·접합학회지
2022 .06
-
Effect of δ-Ferrite Evolution and High-Temperature Annealing on Mechanical Properties of 11Cr3W3Co Ferritic/Martensitic Steel
Metals and Materials International
2016 .01
-
Driving Forces of Silver Nano-porous Sheet Die Bonding at 145 °C and 175 °C in the Air
마이크로전자 및 패키징학회지
2024 .09
-
Formation of Secondary Phases and Their Effect on the Mechanical Properties of Joints Formed by TLP Bonding Using Fe–B–Si Insert Metal in Duplex Stainless Steel
Metals and Materials International
2019 .01
-
석출강화형 Ni 기 초내열합금의 천이액상확산접합
대한용접·접합학회지
2017 .06
-
Effect of bonding parameters on microstructural characteristics during TLP bonding of directionally solidified Ni-based superalloy
대한용접학회 특별강연 및 학술발표대회 개요집
2017 .11
-
600 MPa급 고강도 일반 및 내진 철근의 미세조직, 경도와 인장 특성
한국재료학회지
2017 .01
-
Microstructure and Charpy Impact Properties of FCAW and SAW Heat Affected Zones of 100 mm Thick Steel Plate for Offshore Platforms
Metals and Materials International
2020 .01
-
Influence of Microstructure on Low-Cycle and Extremely-Low-Cycle Fatigue Resistance of Low-Carbon Steels
Metals and Materials International
2021 .10
-
Effect of bonding conditions on TLP bonding characteristics of Ni-based superalloys
대한용접학회 특별강연 및 학술발표대회 개요집
2016 .11
-
탄소강의 펄라이트 분율에 따른 미끄럼 마멸속도 편차 분석
소성·가공
2015 .06
-
Plastic Behavior of Ferrite–Pearlite, Ferrite–Bainite and Ferrite–Martensite Steels: Experiments and Micromechanical Modelling
Metals and Materials International
2021 .01
-
고온동작소자의 패키징을 위한 천이액상확산접합 기술
마이크로전자 및 패키징학회지
2017 .01
이 논문의 저자 정보
최근 본 자료
댓글(0)
0